Charging Port Cap Installation (WI-phx42-116)

Published: 2024-03-18      Revised: 2024-03-18

Click here for a printable version of this procedure.

Items Needed

Part Name	LDAR Part #
6/32 x 3/8 low head socket cap screw	42060
1/16″ Hex bit	4226
Charging Port Cap	42013

1. Charging Port Cap screw removal:
   1. Using the 1/16" hex bit, remove the 6/32 x 3/8 low head socket cap screw by turning counterclockwise.
2. Charging Port Cap installation:
   1. Take the 6/32 x 3/8 low head socket cap screw and place it through the mounting hole of the tether that is connected to the charging port cap.
   2. Thread the 6/32 x 3/8 low head socket cap screw now attached to the charging port cap into the face of the phx42.
   3. Orient the tether so it points left when viewing the front faceplate of the phx42.
   4. Tighten the 6/32 x 3/8 low head socket cap screw until snug, but be careful to NOT overtighten and strip the screw head.

Related articles

• Combustion Pump Replacement (WI-phx42-107)
• Antenna Upgrade (WI-phx42-101)
• Broken Probe Tip Filter Removal (WI-phx42-104)
• Glow Disk Replacement (WI-phx42-103)
• Probe Integrity Test (WI-phx42-114)